Clears Green and Cloudy water by NT Labs

Magiclear

When to use:

When water appears green and/or cloudy. Magiclear causes particles in the water to clump together which can then easily settle out of suspension or be removed by the filter.

Do:

• Aerate pond well e.g. fountain, waterfall or air pump.
• Conduct a partial water change (as much as is practical) before use, especially if the water is extremely green, like “pea soup”.
• Switch off pump only if strong flow rate could prevent particles from clumping BUT remember to switch back on as soon as water clarifies.
• Mix the correct dose in a clean bucket of pond water, then pour evenly around the pond.
• Clean the collected particles from the filter after treatment.
• Without a filter, some clumps may float which can then be removed using a net.
• Use when you have plenty of time to observe the fish and take action in the unlikely event of a reaction.

Don’t:

• Do not use when the dissolved oxygen may be low (e.g. at daybreak, in hot, humid or thundery weather, or within three hours of feeding).
• Do not use if there is nitrite in the water. Use Pondlab test kits to monitor water quality.

Caution: Failure to conduct a partial water change on extremely green water, “like pea soup”, may result in a rapid reduction in oxygen which could be dangerous to fish!

Specifications

Available in the following variations:

250ml, 500ml & 1 Litre

Dose rate 10 ml to 182 litres/40 imp gallons